FUTEK IPM500 (D500) Digital Display - Manual (Page 31)

31
Press Menu
Select Key Press Digit
Select Key Press Value Select
Key
0 00_0 0 No used. ConFG
Meter Configuration
00 _ _0
Operation of front
panel PEAK button
and rear connector for
Peak or Valley Display
0 Peak Display. Also selects “Peak” in
“Peak or Valley” at rear connector.
1 Valley Display. Also selects “Valley” in
“Peak or Valley” at rear connector.
2 Peak (1st push), Valley (2nd push)
3
Front panel Tare
0 0000
Alarm filtering
0 Unfiltered output
1
Filtered output
00000
Peak & Valley filtering
0
Unfiltered Peak & Valley
1 Filtered Peak & Valley
00000
Display filtering
0
Display batch average every 16 readings
1 Display filtered signal
00000 Adaptive filter
threshold
0
Low adaptive filter threshold level
1 High adaptive filter threshold level
FiLtr
Filtering
00000
Input signal filtering.
Can be applied to dis-
play, setpoint, analog
output, data output.
0 Autofilter
1
Batch average, 16 readings
2 Moving average, 0.08 sec.
3
Moving average, 0.15 sec.
4 Moving average, 0.3 sec.
5
Moving average, 0.6 sec.
6 Moving average, 1.2 sec.
7
Moving average, 2.4 sec.
8 Moving average, 4.8 sec.
9
Moving average, 9.6 sec.
A
Unfiltered
OFFst
Offset value
0 .0000 0.0000 0.0000
0.0000 0.0000
Select digit to flash.
Select -9 thru 9 for flashing first digit, 0 thru 9
for other flashing digits. Use offset for display
in Rankine or Kelvin.
Option board dependent menu items
ALSEt . ALS34 dEU1H dEU2H dEU1b dEU2b dEU3H DEU4H DEU3b DEU4b
Menu items related to alarm setup if a relay board is detected. Please see Section16.
AnSEt . An Lo . An Hi ..
Menu items related to analog output if detected. Please see Section 17.
SEr 1 . SEr 2 . SEr 3 . SEr 4 .
Menu items related to serial communications if detected. Please see Section 18.
Menu lockout items
Loc 1 . Loc 2 . Loc 3 .
Menu items used to enable or lock out (hide) menu items. Please see Section 9.