MadgeTech RTDTemp2000 Data Logger - Manual (Page 12)

Page 11
MadgeTech RTDTemp2000
Section 5: RTDTemp2000 Function Reference
5.1 Main Screen
The main screen of the RTDTemp2000 features a real-time display of most
recently measured external probe channel data. At the bottom of the main
screen are tabs corresponding to each of the four function keys. These tabs
are used to access the four main function menus of the RTDTemp2000:
status, statistics, units, and setup. The left side of the main screen and all
subsequent screens of the device is where important status information icons
can be found (detailed in Section 3: Important Status Icons – page 7) includ-
ing recording status, memory status, busy status, external power status, and
battery power status.
5.2 Status Menu
Pressing F1 on the main screen brings up the Status menu. The first screen
that appears in the Status Menu is Run Parameters, but the Memory Status
and Time and Date screens can also be viewed by pressing the F2 and F3
keys respectively.
5.2.i Run Parameters
The Run Parameters screen displays important information regarding the
device’s current recording session. These parameters include the time and
date the recording session started (start time and start date), the time and
date the recording session will end (stop date and stop time) due to either
lack of memory or preprogramming in the MadgeTech software. The rate at
which the RTDTemp2000 is recording (rate) is also displayed. The device’s
current status (either running or stopped) is the last parameter on the Run
Parameters screen.
5.2.ii Memory Status
The Memory Status screen is where all information regarding the RTD-
Temp2000’s memory. This screen displays the percent of memory space
currently available (memory left), the number of readings currently stored
on the device (readings), the maximum number of readings the device can
record (max readings), as well as information about the wrap feature display-
ing either “disabled” or the number of wrap readings currently stored in
memory.