Milestone XProtect Express 2014 - Manual (Page 66)

Milestone XProtect ® Express 2014 Administrator's Manual
www.milestonesys.com 66 Advanced configuration
The two options can be combined , but they cannot overlap in time.
Speedup

Periods of time (example: Mondays from 08.30 until 17.45), shown in olive green:
E-mail notification

Periods of time (example: Mondays from 08.30 until 17.45), shown in blue:
PTZ patrolling

Periods of time (example: Mondays from 08.30 until 17.45), shown in red:

If use of one patrolling profile is followed immediately by use of another, run your mouse
pointer over the red bar to see which patrolling profile applies when.
Properties available in XProtect Enterprise and XProtect Professional only:
SMS notification

Periods of time (example: Mondays from 08.30 until 17.45), shown in green:
Set up a profile
1. In the Schedule Profiles list, select Add new....
2. In the Add Profile dialog, enter a name for the profile. Names must not contain any of these
special characters: < > & ' " \ / : * ? | [ ]
3. In the top right corner of the dialog, select Set camera to start/stop on time to base
subsequent settings on periods of time or Set camera to start/stop on event to base
subsequent settings on events within periods of time.
4. In the calendar section, place your mouse pointer at a required start point, then hold down the
left mouse button, drag the mouse pointer and release at the required end point.
o You specify each day separately.
o You specify time in increments of five minutes. XProtect Express helps you by showing the
time over which your mouse pointer is positioned.
If you base your schedule profile —or parts of it—on events within periods of time, remember to select
Start event and Stop event from the lists below the calendar section.
o Use the Configure events list, located below the other fields to define events that suit your
needs.