Milestone XProtect Express 2014 - Manual (Page 77)

Milestone XProtect ® Express 2014 Administrator's Manual
www.milestonesys.com 77 Advanced configuration
Name Description
Time Unit
Select required unit for live and recording frame rates (per second,
minute, or hour). Note that you can only select time bases that let
you speed up frame rates. Example: If you have specified 15
frames per second in normal mode, you cannot specify 16 frames
per minute or hour in speedup mode.
Speedup On

Motion Detection: Select this to speed up when motion
(see "Motion detection & exclude regions" on page 94) is
detected. Normal frame rates will be resumed immediately
after the last motion is detected.

Event: Select this to speed up when an event occurs and
until another event occurs. Use of speedup on event
requires that events (see "Overview of events and output"
on page 104) have been defined, and that you select start
and stop events in the neighboring columns.
Use the Configure events list, located below the other
fields to define events that suit your needs.

Motion Detection & Event: Select this to speed up when
motion is detected, or when an event occurs and until
another event occurs. Remember to select start and stop
events in the neighboring columns.
Schedule Only
Select this to speed up according to the camera's speedup
schedule (see "Speedup" on page 129) only.
Start Event
Select required start event. The camera will begin using the
speedup frame rates when the start event occurs.
Stop Event
Select required stop event. The camera will return to the normal
frame rates when the stop event occurs.
Camera
Click the Open button to configure detailed and/or camera-specific
settings (such as event notification, PTZ preset positions, and
fisheye view areas) for the selected camera.
Properties available in all XProtect software versions:
Live Frame Rate
Required average frame rate for live video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour). The frame rate must be higher than the frame rate
specified under normal mode.
If the camera supports dual stream and dual stream is enabled, the
Live Frame Rate column will be read-only with the value Dual
streaming
—which cannot be altered.
Recording Frame Rate
Required average frame rate for recorded video from the camera.
Select number of frames, then select the time unit interval (second,
minute or hour). The frame rate must be higher than the frame rate
specified under normal mode.