Milestone XProtect Go 2014 - Manual (Page 69)

Milestone XProtect ® Go 2014 Administrator's Manual
www.milestonesys.com 69 Advanced configuration
E-mail notification

Periods of time (example: Mondays from 08.30 until 17.45), shown in blue:
PTZ patrolling

Periods of time (example: Mondays from 08.30 until 17.45), shown in red:

If use of one patrolling profile is followed immediately by use of another, run your mouse
pointer over the red bar to see which patrolling profile applies when.
Properties available in XProtect Enterprise and XProtect Professional only:
SMS notification

Periods of time (example: Mondays from 08.30 until 17.45), shown in green:
Set up a profile
1. In the Schedule Profiles list, select Add new....
2. In the Add Profile dialog, enter a name for the profile. Names must not contain any of these
special characters: < > & ' " \ / : * ? | [ ]
3. In the top right corner of the dialog, select Set camera to start/stop on time to base
subsequent settings on periods of time or Set camera to start/stop on event to base
subsequent settings on events within periods of time.
4. In the calendar section, place your mouse pointer at a required start point, then hold down the
left mouse button, drag the mouse pointer and release at the required end point.
o You specify each day separately.
o You specify time in increments of five minutes. XProtect Go helps you by showing the time
over which your mouse pointer is positioned.
If you base your schedule profile —or parts of it—on events within periods of time, remember to select
Start event and Stop event from the lists below the calendar section.
o Use the Configure events list, located below the other fields to define events that suit your
needs.
o To delete an unwanted part of a schedule profile, right-click it and select Delete.
o To quickly fill or clear an entire day, double-click the name of the day.
o As an alternative to dragging inside the calendar section, use the Start time, End time
and Day fields, then the Change Period or Set Period button as required. When using the
Start time and End time fields, remember that time is specified in increments of five