Milestone M50 - Manual (Page 82)

Milestone Husky M30/M50 Administrator's Manual
www.milestonesys.com 82 Advanced configuration
Note that you can also specify all of the Frame Rate - MPEG properties individually for each camera
(see "Recording" on page 90) using MPEG.
Name Description
Template
The template can help you configure similar properties quickly. Say
you have 20 cameras and you want to change the recording path,
archiving path, and retention time for all of them. Instead of having
to enter the same three pieces of information 20 times, you can
simply enter them once in the template, and then apply the template
to the 20 cameras with only two clicks.
Apply Template
Select which cameras you want to apply the template for. Use one
of the two Set buttons to actually apply the template.
Camera Name
The name as it appears in the Management Application as well as
in clients. You can overwrite the existing name with a new one.
Names must be unique, and must not contain any of these special
characters: < > & ' " \ / : * ? | [ ]
Dual Stream
Allows you to check if dual streaming is enabled on the camera(s).
Note that the information is read-only. For cameras that support
dual streaming, this can be enabled/disabled as part of individual
cameras' Video (on page 86) properties.
Live FPS Select the camera's live frame rate per second (FPS).
Camera
Click the Open button to configure detailed and/or camera-specific
settings (such as event notification, PTZ preset positions, and
fisheye view areas) for the selected camera.
Select All Click button to select all cameras in the Apply Template column.
Clear All Click button to clear all selections in the Apply Template column.
Set selected template value on
selected cameras
Apply only a selected value from the template to selected cameras.
Set all template values on
selected cameras
Apply all values from the template to selected cameras.
Record Keyframe Only
Keyframes stored at specified intervals record the entire view of the
camera, whereas the following frames record only pixels that
change; this helps greatly reduce the size of MPEG files. Select the
check box if you only want to record keyframes.