Views and their content, Selecting a view, Camera names and colored indicators – Milestone Smart Client 3.6 User Manual
Page 55
Milestone XProtect Smart Client 3.6; User’s Manual
Tip: When viewing live video on the Smart Client's Live tab, you can quickly verify whether the
video stream from a camera is being recorded: Look at the blue bar immediately above the
camera's images. If the video stream from the camera is being recorded, the bar will display
REC
.
Note that you may occasionally see the
REC
letters for short periods only. This is because cameras
may have been configured to record only when there is motion, when a door is open, or similar,
which can lead to many short periods of recordings.
Views and their Content
Selecting a View
You are basically able to select a view for display on the Live tab in two ways:
Note: Illustrations used in the following are examples only; folders and views may have different
names in your version.
•
By selecting the required view in the Live tab’s Views section:
•
By selecting the required view from the Views list located in the upper part of the window:
Tip: If views have been assigned shortcut numbers (see Assigning Shortcut Numbers to Views
on page 26), you will also be able to select a view by using keyboard shortcuts (see Using
Standard Keyboard Shortcuts on page 97).
Camera Names and Colored Indicators
Each camera position in the
view is identified by a bar,
located in the top of each
camera position.
The bar displays the name of
the camera as well as the
name of the device to which
the camera is connected. The
device name is displayed first,
in square brackets, followed by
the camera name.
www.milestonesys.com
Page 55
Viewing Live Video