Prochem Legend SE AD - Manual (Page 11)

INSTALLATION
LEGEND SE 980059 07/23/02
3-3
Prior to starting the installation, first read the
ENTIRE "Installation” section of this manual. Since
the LEGEND SE cleaning unit (with waste tank and
accessories) weighs approximately 886 pounds (976
lbs. if mounted on water tank), consider the following
recommendations before installing this unit.
1. The unit should NOT be mounted in any motor
vehicle of less than 1/2 ton capacity, or 3/4 ton
if equipped with one or more auxiliary fresh
water tanks.
The console with waste tank and accessories
must NOT exceed the vehicle's axle weight limit.
2. If mounting in a trailer, make certain that the
trailer is rated for the total weight of the UNIT
AND TRAILER. Electric or hydraulic brakes
should be provided, and a strict compliance with
any State and Federal vehicle laws must be
maintained.
3. The vehicle tires should have a load rating
above the combined vehicle and unit weight.
4. We do not recommend using flooring materials
that absorb water. This could result in rust and
corrosion of the vehicle floor.
5. Padding under rubber floor mats should be
removed before installing this unit.
6. We highly recommend using a galvanized drip
tray under the console (Part #56-501845, or Part
#56-501930 for units mounted on a water tank.)
7. If using a trailer, the LEGEND SE console
should be positioned so that it balances properly
with respect to the axle. Ten percent (10%) of
the overall unit weight (without accessories or
water) should be on the tongue.
FUEL REQUIREMENTS
Use unleaded gasoline ONLY. DO NOT use any
gasoline additives. We recommend the use of clean,
fresh, unleaded gasoline intended for automotive
use. High octane gasoline should NOT be used with
the engine on this unit.
ENGINE OIL REQUIREMENTS
Use high quality detergent oil of at least API
(American Petroleum Institute) service class SF or
SG. Select the viscosity based on the air
temperature at the time of operation as shown in the
following table. NOTE: Using less than service
class SF or SG oil or extending oil change intervals
longer than recommended can cause engine
damage.
RECOMMENDED SAE VISCOSITY GRADE
TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE
°
F -20 0 20 32 40 60 80 100
°
C -30 -20 -10 0 10 20 30 40
5W-20, 5W-30
10W-30