Prochem Legend SE AD - Manual (Page 25)

OPERATION
LEGEND SE 980059 06/19/03 3-17
Operate this unit and equipment only in a well-
ventilated area. Exhaust fumes contain carbon
monoxide which is an odorless and deadly
poison that can cause severe injury or fatality.
DO NOT operate this unit where the exhaust may
enter any building doorway, window, vent, or
opening of any type.
CHECK FOR ADEQUATE FUEL
Check the fuel tank to be certain there is adequate
fuel to complete the job. This unit uses
approximately .95 to 1.25 gallons of fuel per hour,
depending on the speed setting.
REMOVE TOOLS FROM VEHICLE
Remove any tools or hoses from the van which you
will require.
WATER SUPPLY CONNECTION
NOTE: Before connecting your water hose to the
supply faucet, flush out the faucet until the water is
free of any debris. Flush out any debris which may
be in your water inlet hose.
1. Connect the water supply hose to the water
inlet quick-connect at the front of the unit.
Connect the hose to the water supply faucet.
NOTE: Never use your waste pump outlet hose
as a water inlet hose. Use only clean hoses for
water inlet.
2. Turn the water supply faucet on. The water will
fill the water box .
FILLING AUXILIARY WATER TANK
1. Your cleaning unit may be equipped with an
auxiliary water tank mounted underneath the
console. To fill the auxiliary water tank, open
the ball valve on the water box by turning the
handle on the valve to the vertical position.
2. Connect the water supply hose to the water
inlet quick-connect at the front of the unit.
Connect the hose to the water supply faucet.
3. Turn the water supply faucet on. The water
will flow through the water box and fill the
auxiliary water tank.
4. When the auxiliary water tank is full, close the
ball valve on the water box by turning the
handle on the valve to the horizontal position.
Disconnect the water supply hose from the unit
and plug the hose from the demand pump into
the water inlet quick-connect at the front of the
unit.
5. Turn ON the toggle switch at the front of the
demand pump.
NOTE: Make sure you turn on the demand pump
before you start the unit.