Electrical connections – ROTRONIC CF8-W-Disp-AL User Manual
Page 3
Advertising
Dokument
IMA 210
Rev
1
Page
3 (6)
Electrical connections
The power supply has to be connected to
and
.
is considered as
system ground. If the analogue output is connected to a controller the same ground
reference has to be used for the CF8-W-Disp-AL unit and for the control system!
Unless different transformers are used, special precautions need to be taken.
PLEASE NOTE! The CF8-W-Disp-AL signal and
power supply grounds are common.
PLEASE NOTE! The same ground reference
has to be used for the CF8-W-Disp-AL unit and
for the control system!
If possible keep the sensor powered up after mounting. Connect the analogue output
before measuring.
~
+
Advertising