Setra System Model 470 User Manual
Model 470 digital pressure transducers
Advertising
Table of contents
Document Outline
- Contents
- SECTION ONE: Introduction
- 1.1 About the Setra 470
- 1.2 About this Manual
- SECTION TWO: Installing the Model 470
- 2.1 Power Connections
- 2.2 Pressure Connections
- 2.3 Communications Hardware
- SECTION THREE: Communications Interfacing
- 3.1 Communications Software Protocols
- 3.2 Executing a Function
- 3.3 Clearing a Number or Function
- 3.4 Functions
- 3.5 In Case of Error Messages
- 3.6 Symbols
- 4.2 Converting Engineering Units
- 4.3 User Defined Engineering Units in Nonvolatile Memory
- 4.4 User Defined Engineering Units in Volatile Memory
- 4.5 Tracking Min and Max Values
- 4.6 Setting and Checking Alarm Setpoints in Nonvolatile Memory
- 4.7 Setting and Checking Alarm Setpoints in Volatile Memory
- 4.8 Using the Tare and Zero Function
- 4.9 Repetitive Reporting
- 4.10 Reporting Setup Summary
- 4.11 Digital Altimeter Setting Indicator (DASI)
- SECTION FIVE: Setup Functions
- 5.1 Status After Power is Applied
- 5.2 Changing the Baud Rate
- 5.3 Disabling Engineering Units in Nonvolatile Memory
- 5.4 Disabling Engineering Units in Volatile Memory
- 5.5 Self Diagnostics
- 5.6 Software Revision Number
- 5.7 Verify Function
- 5.8 Stability Indicator
- SECTION SIX: Altitude Measurement Functions
- 6.1 Standard Altitude Measurement
- 6.2 True Corrected Altitude Measurement
- 6.3 Relative Altitude Measurement
- SECTION SEVEN: Calibration
- 7.1 Calibration
- 7.2 Calibration and Program Enable
- 7.3 Zero Calibration
- 7.4 Span Calibration
- Appendix I
- Interface Program Example
- Specifications
- Limited Warranty