Timeguard SLW360 - Manual (Page 9)

8
At this position, the unit should become operative at
approximately the same level of darkness each evening.
Observe the operation of the unit. If the unit is starting
to operate too early (ie. when it is quite light), adjust
the control slightly anti-clockwise. If the unit starts to
operate too late (ie. dusk), adjust the control slightly
clockwise.
Continue to adjust until the unit operates as desired.
Once the unit is set up as desired, refit the top cover by
aligning the arrows shown on diagram E and twisting
clockwise until cover is secure.
Manual Override Mode
The light can be switched on for longer time periods by
use of the Manual Override Mode. This can be
activated at night by using the internal wall switch or
circuit breaker.
Switch the internal wall switch twice (off/on, off/on)
within 2 seconds. The unit will now illuminate
continuously until dawn or until it is switched back
into Detection Mode.
To return to Detection Mode switch the internal wall
switch off and then back on again within 1 second.
SLW360_Instruct_art_2.1.qxd 3/5/06 9:28 am Page 9