TOHO ELECTRONICS TTM-P9 - Manual (Page 9)

8
⑤ Programming mode (The SET lamp lights.)
- This mode will set the program for each pattern.
- Setting the time to 0 minutes will invalidate that particular step.
From reset mode
Hold PATT./STEP down
for 3 seconds.
From operation mode
Pattern number setting mode
Hold PATT./STEP down
for 3 seconds.
Set step 1 temperature.
↓
Press PATT./STEP.
Set it to values up to the maximum
step. (This varies according to the
number of patterns.)
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
Set step 1 time.
Set step 2 temperature.
Set step 2 time.
Set step 3 temperature.
Set step 3 time.
Set step 4 temperature.
Set step 4 time.
Set step 5 temperature.
Set step 5 time.
Set step 6 temperature. PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV  
SV 
Set step 6 time.
Set step 7 temperature.
Set step 7 time.
Set step 8 temperature.
Set step 8 time.
PV  □
SV 
PV  □
SV 
Set step □ temperature.
Set step □ time.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
↓
Press the PATT./STEP key.
- If, in setting a temperature for a specific step, you set it to a value lower than the minimum in the setting range
(displayed as " "), then the steps following that particular step will be invalid and the setting parameter will
not be displayed. The patterned run will come to an end in the step before the one set as " "
- In changing a setting during operation, you cannot change the step temperature or step time during operation.
- If, when starting the PV, you set the temperature setting in step 1 to the minimum in the temperature setting range,
the time for step 1 will be valid. (The PV will be normally started in and after step 2.)
- If all steps are set to their initial values (0°C), setting a temperature will automatically set the next step to the same
temperature as well.
- Setting a step time to a value higher than the maximum in the setting range (displayed as " ") will cause the
product to run continuously at the set temperature in that particular step.