TOHO ELECTRONICS TTX-700 - Manual (Page 7)

2.7 Setting an address
While in the "Set a communications address" screen on the preceding page, operate the ▲ and ▼
keys to make the settings.
The initial value is •.
2.8 Setting a response delay
Set a time from the time when the high-level computer finished sending a "request message" until
the time when it delivers the line and enters an input state.
While in the "Set a response delay" on the preceding page, operate the ▲ and ▼ keys to make the
settings.
The initial value is 0.
* If the response delay is set to a short setting, the communications may not be conducted normally.
* In a real operation, the processing time for this product will be added, in addition to the response
delay.
2.9 Switching communications mode
While in the "Set communications mode switchover" screen on the preceding page, operate the ▲
and ▼ keys to make the settings.
Read only
Read and write
７
Setting range: 1 to 99 stations (It cannot be set to a 0.)
Setting range: 0 to 250ms