AT&T 9002 - Manual (Page 12)

10
Checking Handset Ringer Selection
1 Press p, *.
2 Press 1 for Line 1 or 2 for Line 2.
3 Press *. You will hear the current ringer style selection.
4 Press o to exit.
NOTE: If you’re on a call on one line and a call comes in on the other line,
you will hear an “alert” tone on your call.
Handset Ringer Volume
Adjust the handset ringer volume to high ( H) or low (L) using the switch on
the side of the handset.
Base Ringer Volume
Line 1 and Line 2 ringers on the base have been assigned different ringing
styles. You can adjust the volume of the base ringers to
HIGH, LOW or OFF
using the switches on the side of the base.
Speakerphone Volume
Use + and - on the base to adjust the volume of the
speakerphone.
Temporary Tone
NOTE: If you have touch tone service, you do not need to use the Temporary
Tone feature.
If you have dial pulse (rotary) service, this feature allows you to enter codes or
tones needed to operate answering machines, or use electronic banking
services, calling cards, and other special services. This feature will operate
most special services; however, some services may actually require a touch
tone line. To be sure, ask the company that provides the special service.
1 Dial the call, then press *. Any buttons pressed after this send tone
signals.
2 After you hang up, the phone automatically returns to dial pulse
(rotary) dialing.
OPERATION
9002_book.1AT&T 8/12/98, 4:09 PM 10