AT&T 9002 - Manual (Page 5)

3
Standard
Electrical
Outlet
INSTALLATION
Telephone Jacks
L1 L2 L1/L2
OR
Telephone line cords
Power cord
Modular
Telephone Jacks
Table/Desk Installation
1 Choose a spot near an electrical outlet and a telephone jack.
This phone requires a modular telephone jack and a standard electrical
outlet (110v AC). This outlet should not be controlled by a wall switch.
2 Install the handset battery.
(For an illustration of battery installation, see BATTERIES in this manual.)
•
Remove the battery cover by pressing on the indentation and
sliding downward.
• Install the battery pack so that the metal contacts on the bottom
of the battery are aligned with the charging contacts in the battery
compartment.
• Replace the battery cover by sliding it on its track up over the
battery compartment until it snaps firmly in place.
3 Set the dial mode.
If you have touch tone service, set the switch on the side of the base
to
TONE. If you have dial pulse (rotary) service, set the switch to
PULSE. Even if you have dial pulse service, you can still use telephone
services requiring tone signals. See “Temporar y Tone” in the
OPERATION section of this manual.
9002_book.1AT&T 8/12/98, 4:09 PM 3