Brother DCP-395CN - Manual (Page 42)

Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)
33
3
q
If your wireless device is connected successfully, the display shows Connected for 60 seconds and
configuration is completed.
If the connection failed, the display shows Connection Fail or Wrong Password for 60 seconds.
Note
• If the LCD displays Wrong Password, the password you entered did not match with your access point.
Verify your network settings collected in step a on page 31, then repeat step b to step o to make sure
you have entered the correct information.
• If the LCD displays Connection Fail, make sure your access point is on, and verify your network
settings collected in step a on page 31.
Temporarily move your machine as close as possible to the access point, repeat step b to step o to make
sure you have entered the correct information.
(See Wireless network troubleshooting on page 136.)
r Press OK.
(Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite or
Initial Installation / Install MFL-Pro Suite from the CD-ROM menu.
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.