Brother DCP-395CN - Manual (Page 68)

Wireless configuration for Windows ® using the Brother installer application (For DCP-373CW, DCP-375CW, DCP-377CW,
DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)
59
4
g
Read the Important Notice. Check the box after you confirm the wireless setting is enabled, and then
click Next.
h
Confirm the on-screen message and click Next.
i
Press Menu, a or b to choose Network and press OK. Press a or b to choose WLAN and then press OK.
Press a or b to choose SES/WPS/AOSS and press OK.
(For Touchscreen models)
4
Press MENU. Press Network. Press WLAN and then press SES/WPS/AOSS.
Note
If your wireless access point supports Wi-Fi Protected Setup™ (PIN Method) and you want to configure
your machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi
Protected Setup™ on page 44.
j The machine searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™
or AOSS™ for 2 minutes.
k
Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup™ mode or AOSS™
mode, depending on what is supported by your access point. Please refer to the instruction manual that
came with your access point.