Brother DCP-395CN - Manual (Page 108)

Control panel setup
99
6
For Touchscreen models
6
a Press MENU.
b Press Network.
c
(For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d Press TCP/IP.
e
Press Subnet Mask.
f
Enter the Subnet Mask address.
Press OK.
g Press Stop/Exit.
Gateway
6
This field displays the current gateway or router address used by the machine. If you are not using DHCP or
BOOTP to obtain the gateway or router address, enter the address you wish to assign. If you do not have a
gateway or router, leave this field blank. Check with your network administrator if you are unsure.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c For DCP-373CW, DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW and
MFC-495CW
(For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d Press a or b to choose TCP/IP.
Press OK.
e Press a or b to choose Gateway.
Press OK.
f Enter the Gateway address.
Press OK.
Note
• For DCP-365CN, DCP-373CW, DCP-375CW and DCP-377CW, press a or b repeatedly to enter the first
three-digit number for the Gateway address. Press OK to enter the second three-digit number. Repeat this
step until you have entered the fourth three-digit number to complete the Gateway address. Press OK.
• DCP-395CN, DCP-593CW, DCP-595CW and DCP-597CW, press a or b repeatedly to enter the first
three-digit number for the Gateway address. Press d to enter the second three-digit number. Repeat this
step until you have entered the fourth three-digit number to complete the Gateway address. Press OK.
g Press Stop/Exit.