Brother DCP-395CN - Manual (Page 120)

Control panel setup
111
6
Ethernet (Not available for MFC-253CW, MFC-255CW and MFC-257CW)
6
Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
For DCP-373CW, DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW and
MFC-495CW
Press a or b to choose Wired LAN.
Press OK.
d Press a or b to choose Ethernet.
Press OK.
e
(For DCP-365CN, DCP-373CW, DCP-375CW, DCP-377CW and MFC-295CN)
Press a or b to choose Auto/100B-FD/100B-HD/10B-FD/10B-HD.
Press OK.
(For DCP-395CN, DCP-593CW, DCP-595CW, DCP-597CW and MFC-495CW)
Press d or c to choose Auto/100B-FD/100B-HD/10B-FD/10B-HD.
Press OK.
f
Press Stop/Exit.
For Touchscreen models
6
a Press MENU.
b Press Network.
c Press Wired LAN.
d
Press Ethernet.
e
Press Auto/100B-FD/100B-HD/10B-FD/10B-HD.
f
Press Stop/Exit.