Brother MFC-640CW - Manual (Page 75)

69
4
To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can
set or change the address settings from the control panel (See the Network User’s Guide on the CD-ROM)
or by using the BRAdmin Professional software. If you installed the machine following the instructions for a
network user in the Quick Setup Guide then the machine should already be configured for your network.
Note
• For network scanning, a maximum of 25 clients can be connected to one machine on a network. For
example, if 30 clients try to connect at a time, 5 of those clients will not be shown on the LCD.
• If your PC is protected by a firewall, and is unable to scan you may need to configure the firewall settings
to allow UDP port number 137 and 54925. Visit the Brother Solutions Center (http://solutions.brother.com)
for more information.
Before using Network Scanning
4
Network license
4
This product includes a PC license for up to 2 Users.
This license supports the installation of the MFL-Pro Software Suite including ScanSoft
®
PaperPort
®
on up
to 2 PCs on the network.
If you want to use more than 2 PCs with ScanSoft
®
PaperPort
®
installed, please buy the Brother NL-5 pack
which is a multiple PC license agreement pack for up to 5 additional users. To buy the NL-5 pack, contact
your Brother dealer.
Network Scanning
(For models with built-in network support)
4