Brother MFC-J4410DW - Manual (Page 219)

Network Scanning
211
13
c
Press s or t to display Factory Reset.
Press Factory Reset.
d
Press Yes.
e
Press .
Scan to Image
13
When you choose Scan to Image, your document will be scanned and sent directly to the computer you
designated on your network. The ControlCenter software will launch the default graphics application on the
designated computer.
For MFC-J4510DW/J4710DW
13
a
Load your document.
b
Press (Scan).
c
Swipe left or right to display (to Image).
d
Press (to Image).
The icon moves to the middle and is highlighted in blue.
e
Press OK.
f
Swipe up or down, or press a or b to display the computer you want to send to.
g
Press the computer name.
If the LCD prompts you to enter a PIN number, enter the 4-digit PIN number for the computer on the LCD.
Press OK.
Do one of the following:
 If you want to use the default settings, go to m.
 If you want to change the default settings, go to h.
NOTE
If you want to save the computer as a shortcut, press Save as Shortcut.
h
Press Options.
i
(For MFC-J4710DW)
If you want to use 2-sided scanning, press 2-sided Scan.
Press 2-sided Scan: Long Edge or 2-sided Scan: Short Edge.
j Press Set with Touch Panel.
Press On.