Brother MFC-845CW - Manual (Page 13)

Setting Up the Machine
11
11 Print quality check
1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and Press
2
Make sure paper is loaded in the paper tray.
Press Color Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3
Check the quality of the four color blocks on the
sheet.
(black/yellow/cyan/magenta)
Improper Setup
Avoid touching the printed surface of the
paper immediately after printing, the surface
may not be completely dry and may stain your
fingers.
4
The LCD shows:
Is Quality OK?
Yes iPress 1
No
iPress 2
5
Do one of the following:
„ If all lines are clear and visible, press
1 (Yes) on the dial pad to finish the quality
check.
„ If you can see missing short lines, press
2 (No) on the dial pad and go to step
6.
6
The LCD asks you if the print quality is OK for
black and color. Press 1 (Yes) or 2 (No) on the
dial pad.
Black OK?
Yes
iPress 1
No iPress 2
Color OK?
Yes iPress 1
No
iPress 2
After pressing 1 (Yes) or 2 (No) for both black
and color, the LCD shows:
Start Cleaning?
Yes iPress 1
No
iPress 2
7
Press 1 (Yes), the machine will then start
cleaning the colors.
8
After cleaning is finished, press Color Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step
3.
OK Poor