Brother MFC-3820CN - Manual (Page 89)

6 - 9 SETUP SEND
Dual Access (Not available for color faxes)
You can dial a number, and begin scanning the fax into memory—
even when the MFC is sending from memory or receiving faxes. The
LCD shows the new job number and available memory.
Real Time Transmission
When you are sending a fax, the MFC will scan the originals into the
memory before sending. Then, as soon as the phone line is free, the
MFC will start dialing and sending.
If the memory becomes full, the MFC will send the original in real
time (even if
Real Time TX is set to Off ).
Sometimes, you may want to send an important original immediately,
without waiting for memory transmission. You can set
Real Time
TX to On for all documents or for the next fax only.
If you want to fax multiple pages, use Dual Access.
(See Dual Access (Not available for color faxes) on page 6-9.)
1
If it is not illuminated in green, press ( Fax ).
2
Load your original. (See Load originals on page 2-1.)
3
Press Menu/Set , 2 , 2 , 5 .
Your MFC normally uses Dual Access. However, to send a color
fax, the MFC will send the original in real time (even if
Real
Time TX is Off ).
The number of pages you can scan into the memory will vary
depending on the data that is printed on them.
If you get a Out of Memory message while scanning the first
page of a fax, press Stop/Exit to cancel scanning. If you get a
Out of Memory message while scanning a subsequent page,
you can press Black Start to send the pages scanned so far,
or press Stop/Exit to cancel the operation.
5.Real Time TX