Brother DCP-350C - Manual (Page 41)

Making copies
27
4
Note
You can save some of the settings that
you use most often by setting them as
default. These settings will stay until you
change them again. (See Setting your
changes as the new default on page 30.)
Changing copy quality
4
You can choose the copy quality. The factory
setting is Normal.
a
Load your document.
b
Enter the number of copies you want.
c
Press a or b to choose Quality.
Press OK.
d
Press a or b to choose Fast, Normal or
Best
.
Press OK.
e
If you do not want to change additional
settings, press Black Start or
Color Start.
Enlarging or reducing the
image copied
4
You can choose an enlargement or reduction ratio.
a
Load your document.
b
Enter the number of copies you want.
c
Press a or b to choose
Enlarge/Reduce
.
Press OK.
d
Do one of the following.
„ Press a or b to choose the
enlargement or reduction ratio you
want. Press OK.
„ Press a or b to choose
Custom(25-400%)
. Press + or - to
enter an enlargement or reduction
ratio from 25% to 400%. Press OK.
e
If you do not want to change additional
settings, press Black Start or
Color Start.
Note
Page Layout Options are not available
with Enlarge/Reduce settings.
Fast
Fast copy speed and lowest
amount of ink used. Use this
setting to save time (documents to
be proof read, large documents or
many copies).
Normal
Recommended setting for ordinary
printouts. Good copy quality with
adequate copy speed.
Best
Use this setting to copy precise
images such as photographs. The
highest resolution and slowest
speed.
50%
69% A4iA5
78%
(DCP-350C)
78% LGLiLTR
(DCP-560CN)
83%
(DCP-350C)
83% LGLiA4
(DCP-560CN)
93% A4iLTR
97% LTRiA4
100%
*
104% EXEiLTR
142% A5iA4
186% 4"x6"iLTR
198% 4"x6"iA4
200%
Custom(25-400%)