ATO iSee 360i - Manual (Page 66)

Section 7. Maintenance and Troubleshooting
- 60 - iSee 360i User’s Manual
Viewing Release Notes
Release notes that tell about changes made in the new
firmware are copied to the Notes section of your iPod.
To view the release notes:
1. Leave the iSee power off and turn the iPod on.
2. On the iPod, navigate to
Extras | Notes and view the iSee
release notes.
Troubleshooting Tips
Problem Solution
There’s a delay
before starting a
video or exiting from
a playing video.
This is normal. The iSee uses the
iPod’s hard disk, and hard disks
often have some delay in
responsiveness.
I turned on the iSee,
but never see the “Do
not disconnect”
message on the iPod.
Turn the iPod off and remove it.
Turn the iSee off. Then reinsert the
iPod into the iSee and turn the iSee
on.
No display on iSee Make sure AC adapter or USB
cable is securely attached to iSee.
Make sure iPod is plugged securely
into the iSee. The iSee requires an
iPod in order to operate.
Make sure you have not selected
TV-Out. When TV-Out is enabled,
the iSee screen is blank.
If you have just switched to
TV-Out, you can press
Select (
) again to revert to
the iSee display.
Or turn the iSee off, then on
again to restore the display to
the iSee screen.