American Telecom AM64/128A - Manual (Page 49)

Appendix D - Approvals AM64/128A User Manual
A-10
APPENDIX D - Approvals
LVD - Safety Statements:
Power Rating Information - AC Source:
1.
Voltage Range: 230/120Vac.
2. Current Range 40mA at 230V and 85mA at 120V.
3. Frequency Range 50/60Hz.
Safety Instructions:
1.
The apparatus must be installed and maintained by COMPETENT SERVICE
PERSONNEL.
2. Disconnect power and line connector on the modem before attempting to change
the PIM module.
3. The apparatus is a class 1 device and must be connected to a suitable earth.
Disconnect device statement:
The mains plug on the equipment serves as the disconnect device, therefore a socket outlet
shall be installed near the equipment and shall be easily accessible.
TTE - Network and Safety statements
The AC power connection has a saftey status of HAZARDOUS VOLTAGE.
The line Network connection has a safety status of TNV-1
The X.21 Network Interface Port has a safety status of Un-earthed SELV.
The X.21bis Network Interface Port has a safety status of Un-earthed SELV.
The V.35 Network Interface Port has a safety status of Un-Earthed SELV.
The V36 Network Interface Port has a safety status of Earthed SELV.
The RS530 Network Interface Port has a safety status of Earthed SELV.
The G.703 Digital Network Interface Port has a safety status of Earthed SELV.
Caution - Electrostatic Sensitive Device
Electrostatic precautions should be used at all times when handling the Plug in Modules.To
ensure continued compliance, ensure any port or connector when not in use is protected
by the cover or dummy plug supplied.
EMC - Statements:
This is a class B product (with exception to its use with the V.35 Interface which renders the
unit as a Class A product). In a domestic environment this product may cause radio
interefence in which case the user may be required to take adequate measures.
EMC Test conditions:
During EMC testing, the digital port cable used was of a screened type. To ensure
compliance, it is recommended that a screened cable is used on this port when in use.
Manufacturers Declaration* ATL Telecom Ltd declares that this product is in conformity
with the essential requirements of the 'R&TTE directives 1999/5/EC'
* A copy of the Declaration of Conformity is available upon request from ATL Telecom Ltd.