Arcam Integrated Amplifier - Manual (Page 7)

7
Using your A32 integrated amplifi er
FRONT PANEL CONTROLS
This section describes how to operate your amplifier.
If your amplifier has not been installed for you, you should first read
the section ‘Installation: A32’ on page 5.
POWER (and power indicator light)
bm
Switches the unit on and off. (You can also switch the amplifier into
standby mode with the remote control handset.)
The light indicates the status of the amplifier. A red light means the
amplifier is in standby mode (press the
POWER/STANDBY button on the
remote control, or the POWER button on the front panel, to switch
between standby and powered-up modes).
Source selectors
8
These buttons select the source connected to the corresponding
input. A light above the relevant button indicates which input is
currently selected and it will also usually be shown on the display.
Note that the VCR input may be used with a VCR or a second recording
unit (e.g. cassette deck).
TONE
9
Switches the tone circuits on and off, including settings for individual
sources. Note that the tone LED does not light unless a tone setting
has been made. (see page 8).
Control knob, SELECT and ENTER
746
The control knob has two functions:
■ as a volume control, to adjust the output of loudspeakers and
headphones connected to the amplifier, and of the pre-amp
output (
PRE OUT ).
■ when used in conjunction with the SELECT and ENTER buttons, to
customise amplifier settings (see page 9).
Volume control settings
It is important to realise that the position of the volume control is not
an accurate indication of the power delivered to your loudspeakers.
The amplifier often delivers its full power long before the volume
control reaches its maximum position, particularly when listening
to heavily recorded compact discs. However the amplifier also has
to be capable of giving full power output from much lower level
sources, such as tuners and cassette decks. Using these sources, the
volume control setting may be much higher before distortion (audible
overload) sets in. To compensate for this, the input levels of each
source may be individually adjusted to avoid accidental overload (see
page 9).
SP1 and SP2
bk
These buttons allow you to select and deselect the main ( SP1 ) and
secondary ( SP2 ) set of speakers attached to your amplifier.
The light above each button glows if the corresponding speakers
are currently selected. If both lights are out the amplifier will appear
not to work, as all speakers are switched off! If both are on, with
two pairs of low impedance speakers connected, overloads are more
likely. Overloading the amplifier may cause it to shut down because of
overheating.
PHONES
bl
This socket accepts headphones with an impedance rating between
8
Ω and 2k Ω , fitted with a 1/4-inch stereo jack plug. If you wish to listen
on headphones only, use the SP1 and SP2 buttons (if necessary) to mute
the speakers.
The headphone socket is always active. To avoid possible damage,
always disconnect headphones prior to switching the amplifier on or
off.
Remote control receiver
1
The remote control’s infrared receiver is positioned behind the ‘FMJ’
badge. Ensure the receiver is in a clear line of sight from the remote
control to allow signals to be received.
MODE, UP and DOWN
2 5
These buttons are mainly for use with future optional modules,
however the
UP and DOWN buttons are used with the basic A32
amplifier to move the cursor when customising the ‘Welcome message’
(see page 9).
3 2
1 6
7 8 9 bk
A32 INTEGRATED AMPLIFIER
SP1 SP2 POWER PHONES
4 bl bm
PHONO/AUX CD TUNER AV DVD VCR TAPE TONE
ENTER
MODE RECORD SELECT
5