P.77, P.77), Cop y – Canon EOS Rebel T5i 18-55mm IS STM Lens Kit User Manual
Page 78
77
Checking the dust erased spots
After step 5, you can display and check in detail the erased dust spots
one by one by pressing the <Shift> + <F> keys. (Press the <Shift> +
<B> keys to return to the previous dust spot.)
Canceling a specified erased dust spot only
After step 5, you can press the <Shift> + <F> keys or the <Shift> +
<B> keys to display the erased dust spot, and then press the <Shift>
+ <Del> keys to cancel only the erased dust spot displayed.
Switch between full screen display/normal screen display using
shortcut keys
You can also switch between full screen display/normal screen
display by pressing the <Alt> + <Enter> keys.
Applying the dust erasure result to another image
You can apply dust erasure to the same place in another image by
clicking the [Copy] button to copy the dust erasure results and then
displaying the other image to which you want to apply the results and
clicking the [Paste] button.
To apply dust erasure to the same place in several other images, you
can efficiently erase dust spots by clicking the images while holding
down the <Ctrl> key in the main window, or, by selecting multiple
images by clicking the first image and then clicking the last image
while holding down the <Shift> key, and then displaying the copy
stamp window.
Useful functions of the copy stamp window
For a list of the copy stamp window functions, see
For images shot with ISO speed range expansion set, noticeable
noise may make it difficult to view dust spots in the copy stamp
window, so using this function is not recommended.
You can correct an image by pasting a section copied from another part
of the image to an unwanted part of the image.
1
Follow steps 1 to 3 in “Manually Erasing Dust (Repair
Function)”
2
Specify the section to be copied.
Click on the section that is to be the copy source while holding
down the <Alt> key.
To change the section that is to be the copy source, perform the
operation above again.
To fix the position of the copy source, checkmark [Fix Copy
Source position].
3
Correct the image.
Click or drag on the section you want to correct on the image. [
+
]
in the window indicates the copy source and [ ] indicates the
copy destination.
The copied image is pasted in the position to which it was
dragged.
For [Pen type], you can select from [Brush] (the pasted image’s
borders simulate a brush) and [Pencil] (the pasted image’s
borders are sharp).
4
Click the [OK] button to return to the main window.
The [
] mark
is displayed on a corrected image.
Erasing Unwanted Parts of an Image (Copy Stamp Function)
COP
Y