Canon imagePROGRAF iPF760 - Manual (Page 499)

Setting Item Description, Instructions
Adjust
Printer Feed Pri-
ority Adjust
Length Adjust-
ment-
Print A:High Print a test pattern for particular types of paper to compensate
for paper stretching or shrinkage, after which you enter the
amount of adjustment. (See "Adjusting Line Length (Adjust
Length).")
→P.564
B:Standard/Draft
Change
Settings A:High Displayed when you have selected Feed Priority > Adj. Prior-
ity > Print Length.
Adjustment relative to the amount of stretching or shrinkage of
the current paper.
Enter either the adjustment results from AdjustmentPrint or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower adjust-
ment value.
B:Standard/Draft
Mainte-
nance Head Cleaning Clean the Printhead. (See "Cleaning the Printhead.")
→P.576
Choose Head Cleaning A if printing is faint, oddly colored, or
contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or if printing
is not improved by Head Cleaning A.
Nozzle Check Print a test pattern to check the nozzles.
Replace P.head When replacing the Printhead, choose Yes and follow the in-
structions on the screen. (See "Replacing the Printhead.")
→P.577
Not displayed during a warning message that the remaining
Maintenance Cartridge capacity is low.
Repl. maint cart When replacing the Maintenance Cartridge, choose Yes and
follow the instructions on the screen. (See "Replacing the
Maintenance Cartridge.")
→P.584
Head Info Indicates information about the printhead.
GL2 Replot Print the previous GL2 print job again.
GL2 BufferClear Clear the print data in the replot buffer.
GL2 Set-
tings Quality
Manager Color
Mode Monochrome Print in monochrome.
Color (CAD) 1 Print in standard colors.
Color (CAD) 2 Print in brighter colors.
Color (CAD) 3 Print emulating the following printers, in colors resembling col-
ors produced by these printers: Canon iPF500, iPF600,
iPF700, iPF510, iPF610, iPF710, iPF605, iPF720, iPF810,
iPF815, iPF820, and iPF825. (*2)
Color (CAD) 4 Print emulating the HP Designjet 500/800, in colors resembling
colors produced by these printers.(*2)
Color (CAD) 5 Print emulating the HP Designjet 1000, in colors resembling
colors produced by this printer.(*2)
Print Quality Choose the print quality.
Input Resolution Choose the printer input resolution, 600dpi or 300dpi.
Print (Economy) Although printing quality is diminished, less ink is consumed
than in regular printing. Select On to conserve ink.
Paper
Manager Paper Source Choose the source of paper for HP-GL/2 printing.
Margin Specify the margin around paper. The margin for the trailing
edge of sheets is 23 mm (0.9 in).
iPF760 Menu Settings
User's Guide
Control Panel
Printer Menu
499