Insufficient paper for job, This paper cannot be used as size is not supported – Canon imagePROGRAF iPF8400 User Manual

Page 135

Advertising

Cause

Corrective Action

If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
(See "Attaching the Roll Holder to Rolls.")

→P.9

Because the Platen is soiled with ink or other substances, the size of the clear film
cannot be detected.

Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cover.")

→P.53

Insufficient paper for job

Cause

Corrective Action

The printer has received a print job longer than the amount of roll paper left when Man-
ageRemainRoll in the Control Panel menu is On.

Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during
the print job and you may not be able to print
all of the document.

Press ▲ or ▼ to select Change Paper, and
then press the OK button.
Change the Paper Source of the printer driv-
er, or replace the roll with a roll that has
enough paper for the print job, and then printt.
When using the Media Take-up Unit, press ▲
or ▼ to select Stop Printing, and then press
the OK button to stop printing.
Remove the printed document from the Media
Take-up Unit, replace the roll with a roll that
has enough paper for the print job, and then
try printing again.
(See "Removing the Roll from the Printer.")