Canon XF105 - Manual (Page 72)

Setting the Time Code
72
NOTES
• When the [J Other Functions] [Frame Rate] setting is set to [24P], the frames value in the time code runs
from 0 to 23. For other settings, it runs from 0 to 29.
• b When the [J Other Functions] [Frame Rate] setting is set to [24P], the frames value in the time
code signal output from the HD/ SD SDI terminal or GENLOCK/TC terminal runs from 0 to 29.
• When you are using interval recording, frame recording or slow & fast motion recording mode, you cannot
select the [Free Run] option for the [Preset] running mode. Conversely, when you are using pre-recording
mode, [Free Run] is automatically set and cannot be changed.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• As long as the built-in rechargeable lithium battery is charged and you selected the [Free Run] option, the time
code continues to run even if you disconnect all other power sources. However, this is less accurate than
when the camcorder is on.
• If you set an assignable button to [Time Code] (0 97), you can press the button to open the [L TC/UB
Setup] [Time Code] submenu.
COP
Y