Electrolux EIDW1805KS - Manual (Page 9)

9
Installation Instructions
STEP 10 SECURE DISHWASHER
TO COUNTERTOP OR CABINET
STEP 11 CONNECT WATER
SUPPLY
• Fasten the dishwasher to the underside of the
countertop with the 2 Phillips special head
screws provided.
Method 2: Securew dishwasher with side-mount-
ing brackets.
IMPORTANT
–
Check to be
sure that door springs does not rub or contact the
fill hose or water supply line. Test by opening and
closing the door. Re-route th lines if a rubbing
noise or interference occurs.
In this step you will need the 2 Phillips special
head screws set aside prior to Step 1. The
dishwasher must be secured to the countertop or
the cabinet sides. When countertops are mad of
wood, use Method 1. When countertops are
granite or other materials that will not accept
screws, use Method 2 tos secure dishwsher at the
sides.
IMPORTANT : Drive Screws straight and flush.
Protruding screw heads will scratch the top or
sides of the control panel and can interfere with
door closing.
Method 1: Secure dishwasher to Wood
Countertop.
Connect water supply to 90° elbow.
• Slide compression nut, then ferrule over end of
water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with
compression nut.
• Remove plug buttons (one on each side).
When step is complete, close dishwasher door
and verify that gap between countertop and top of
dishwasher door is at least 1/2".
• Install screws through the dishwasher side
mount bracket and into the adjacent cabinet on
each side. Reinstall plug buttons.
Figure S-1
Figure S-2