Electrolux EFP6440X - Manual (Page 43)

43
Mounting accessories included
1 allen spanner (for TORX screws).
4 screws 4,5 x 16
6 screws 4 x 8
4 Brackets
1 Flange
Montage
• Fix the 2 brackets D (Fig. 7) to the side panel
of the wall cabinet (one per side) with 2 screws
for each bracket (align the bracket to lower
border).
Position the bracket to touch the back border of
the wall cabinet, considering that the back
border of the bracket corresponds to the back
side of the cooker hood;
Drill a hole on the ceiling of the wall cabinet to
pass the discharge tube and the electrical cable.
• Fix 2 brackets E (Fig. 8) to the sides of the
cooker hood (one per side).
a. remove the extractable part of the cooker
hood;
b. remove the grease filter/s;
c. fix the brackets with two screws P per
bracket from inside the cooker hood, affix them
as more as possible upwards (air exit side) and
then serrate the screws.
• Insert the cooker hood in the wall cabinet,
ensuring to position the cooker hood bracket E
above the wall cabinet bracket D (Fig. 9).
Thread the electric cable through the
appropriate perforation.
• Block the cooker hood with two screws on the
frontal part (Fig. 9 – one per side).
• Connect the cable to the electrical mains, only
when the installation is completed.
• If the cooker hood should not touch perfectly
with the lower border of the wall cabinet then
regulate by loosening the screws P of the
brackets E mounted on the cooker hood (Fig.
8), it will be possible to regulate the perfect
matching of the cooker hood and wall cabinet,
once regulated tighten the screws.
• Regulate the gliding of the extractable drawer in
D
E
Ø 4 x 8
Ø 150mm
Ø 150mm
D
min.
135
87
Ø 4,5x16
B
E
E
P - Ø 4 x 8
Fig. 7
Fig. 8
Fig. 9