ATEN ALTUSEN KH1516 - Manual (Page 45)

Chapter 4. OSD Operation
31
(Continued from previous page.)
Setting Function
RESET STATION
IDS If you change the position of one of the Stations in the daisy chain,
the OSD settings will no longer correspond to the new situation.
This function directs the OSD to rescan the Station positions of the
entire installation and updates the OSD so that the OSD Station
information corresponds to the new physical layout.
Only the Station Numbers get updated. Except for the Port
Names, all Administrator settings (such as Set Accessible Ports,
Set Quick View Ports, etc.), for all of the computers affected by the
change, have to be manually redone.
FIRMWARE
UPGRADE In order to upgrade the KH1508 / KH1516 's firmware
(see KH1508 / KH1516 Upgrade, page 43), you must first invoke
Firmware Upgrade Mode with this setting.
PORT SETTING This screen lets you set three functions for the port: the length of
the Cat 5 cable from the port to the KVM Adapter; the Operating
System used by the computer connected to the port; and the
Keyboard Language for the computer connected to the port.
Š
Press [Spacebar] to cycle through the cable length settings:
S: Short – for up to 25 m
M: Medium – for between 20 and 40 m
L: Long – for above 35 m
An S, M, or L appears next to the port in the L column to
indicate the choice.
Š
Press [Enter] to cycle through the Operating System settings:
PC, Mac, or Sun.
Š
Press [Tab] to cycle through the Keyboard Language settings:
USA, GBR, FRA, JPN, KOR.
Note: For German or Chinese, select USA.
ADAPTER
UPGRADE In order to upgrade the Adapter Cables’ firmware (see Adapter
Cable Upgrade, page 49), you must first invoke its Upgrade Mode
with this setting.
kh15816-v1.book Page 31 Wednesday, October 25, 2006 11:05 AM