Bosch WAP24200UC - Manual (Page 13)

13
turned off if the washer is going to be unused for
extended periods of time.
▯
Make sure rubber washers are in place at both ends of
the water supply hose. Missing washers could cause
leaks.
▯
The connection points are under full water pressure.
Turn on the water tap and check for leaks.
▯
Periodically inspect the water supply hose and replace
with a new hose if cuts, kinks or leaks are observed.
Water connection hoses
▯
red - Hot water-hose
▯
blue - Cold water-hose
Attach this end to water tap. Hand tighten only.
Attach this end of the hose to the back of the washing
machine. Hand tighten only.
Water drain hose connection
NOTICES
▯
Do not reuse an old drain hose. Only use the drain
hose and parts included with your washer.
▯
Do not kink or modify the water drain hose.
Height of drain point
Height difference between the floor and drainage point:
max. 39 in. (100 cm).
Types of drainage hookups
Standpipe
Attach the drain hose using the elbow included with your
washer.
Fit the drain hose to the elbow provided leaving a
maximum of 4 inches of drain hose projecting. Insert this
section of the drain hose into the drain pipe. Secure the
elbow and hose with a nylon tie strap or the equivalent to
keep the hose from coming out of the drain pipe during
use.
Sink siphon
Secure the drain hose to the sink siphon using a Ø 0.9 -
1.6 in. (20-44 mm) hose clip (available from a hardware
store).
Wash Basin
9 WARNING
SCALDING
When washing at high temperatures, there is a risk
of scalding if you touch hot suds, e.g. when
pumping out hot suds into a wash basin.
Do not reach into the hot suds.
9 CAUTION
APPLIANCE DAMAGE/DAMAGE TO TEXTILES
If the end of the drain hose is dipped into the
pumped-out water, water can be sucked back into
the appliance and can damage the appliance/
textiles.
Make sure that:
▯
The sealing plugs do not seal the drain of the wash
basin.
▯
The end of the drain hose does not dip into the
pumped-out water.
▯
The water flows out fast enough.
GUDLQ
SLSH
FDEOHWLH
LQ