Acer Aspire T160 - Manual (Page 48)

39 Chapter 2
Onboard I/O Chip Setup
Parameter Description Options
Onboard FDC Controller Select Enabled if your system has
a floppy disk controller (FDC)
installed on the system board and
you wish to use it. If you install an
add-in FDC or the system has no
floppy drive, select Disabled in this
field. Enabled
Disabled
Onboard Serial Port 1 Select a logical COM port name
and matching address for the
serial port. Select an address and
corresponding interrupt for the
serial port.
UR2 Duplex Mode In an infrared port mode, this field
appears. Full-duplex mode
permits simultaneous two-
direction transmission. Half-duplex
mode permits transmission in one
direction only at a time. Select the
value required by the IR device
connected to the IR port.
Onboard Parallel Port Select a logical LPT port address
and corresponding interrupt for the
physical parallel port.
Onboard FDC Controller [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
UART Mode Select
[IrDA]
UR2 Duplex Mode [Half]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
ECP Mode Use DMA 3
Phoenix - Award BIOS CMOS Setup Utility
Onboard Device Setup
Item Help
Menu Level
.
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help