Aastra Telecom BE-3872 - Manual (Page 11)

Setting the Ring Count
The ring count setting will prompt the
BE-3872 to pick up an incoming call
with the answering machine after 2, 4,
or TS (tollsaver 2/4) rings. There is a
ringer switch on the bottom of the base;
adjust this switch to the number of rings
that you desire.
2R: The unit will pick up after two rings.
4R: The unit will pick up after four rings.
TS: The answering machine will pick up after four rings if there are no new
messages or after two rings if there are. This enables you to hang up after the
third ring when checking your messages remotely (which saves toll charges).
Setting the Day and Time
While in standby mode, press the [Time Set] key and the currently programmed
date and time is heard; [rc] shows in the message counter display.
To program the day and time:
1. Press and hold [Time Set] for three
seconds until “Monday” is heard.
2. Press the /Repeat or /Skip key to
select the current day of the week.
3. Press [Time Set] to store that information.
“12 AM” will be announced.
4. Press /Repeat or /Skip to select
the current hour (1AM through 12AM or
1PM through 12PM).
5. Press [Time Set]. “00” will be announced.
Press /Repeat or /Skip as many
times necessary to set the current minutes
(01 through 59).
6. Press [Time Set] again. The information
will be stored and the new day and time
will be announced.
ANSWERING SYSTEM SETUP
Using the Handset Finder (PAGE)
1. Press on the base. The In Use LED will light. If the handset is
within range, a series of beeps will sound for approximately 60 seconds.
2. Place the handset back into the base or press any key on the handset to
stop the page/find feature.
Security Code
The security code prevents your cordless telephone conversation from being
accessed by a phone on a different line. If the handset is placed in the base to
charge, the handset will automatically select the code from a total of over
65,000 combinations. The code is changed every time the handset is placed in
the cradle (indicated by a beep).
Channel Changing
If you are experiencing interference during a telephone call, press the c
key. The BE-3872 will scan up to 40 channels and select the clearest one to
provide the best possible reception.
Out-of-Range Warning
If you venture too far from the base, the handset will beep. Reverse your
direction to re-establish connection with the base or the call will be dropped.
When the base detects that the handset has been out of range for 20
continuous seconds it will release the engaged line.
19
OTHER HANDSET FEATURES
PAGE
20
Ring Count Switch
8 7