The data jack, The headset jack, Belt-clip – Aastra Telecom BE-3872 User Manual

Page 9: Headset and data jack, Battery duration, When the battery needs charging, When to purchase a new battery pack, Battery installation

Advertising
background image

The Data Jack

The jack located on the side of the
telephone labeled "DATA" is a
convenience jack. It is useful for
connecting a fax machine or modem when
there is no telephone jack available for
that device.

The Headset Jack

The headset jack is located on the side of the
handset and is a standard 2.5mm plug. Simply
plug the headset (not included) into the jack and
the headset will be active.

Note: When the headset is plugged into the

telephone, the microphone and earpiece
on the handset are not active.

Belt-Clip

Be sure to remove the belt-clip filler cap prior to installing the
belt-clip. Install the belt-clip as shown.

To remove the belt-clip, squeeze the release at the top of the
clip where it attaches to the phone, and gently pull the clip up
and out of the handset.

16

HEADSET AND DATA JACK

Talk

Flash

Redial

1

2

ABC

3

DEF

4

5

JKL

6

MNO

GHI

7

8

TUV

9

WXYZ

PQRS

2.4

GHz

In Use

Low Batt.

Data Jack

Headset Jack

Belt-clip

To install the 3.6V 400mAh cordless handset battery pack:

1. Slide open the battery compartment door on the back of

the handset.

2. Insert the battery into the battery compartment and then

plug the battery connector into the 2-pin connector
located just inside the battery compartment.

3. Close the battery compartment door and place the

handset on the base unit cradle.

4. Once you have installed the battery pack and placed the

handset on the base you will hear a tone indicating the
handset has connected with the base and will
successfully charge.

5. IMPORTANT: Charge the battery pack for at least 12

hours before using the handset the first time.

6. The CHARGE LED on the base illuminates when the

handset is making contact with the charge terminals.

Battery Duration

A fully charged battery lasts for approximately:
• 5 hours when you use the handset continuously (talk

time).

• 7 days when the handset is not in use (standby).

When the Battery Needs Charging

• The handset will beep.
• The In Use/Low Batt. LED will flash slowly.

When to Purchase a New Battery Pack

If the battery lasts only a few minutes even after a full charge, the usable life of
the battery has expired and needs to be replaced.

For replacement batteries

visit http://www.bell-equipment.com/support or
you can contact Aastra Telecom customer support center

at 1-888-663-1505 for information about how to order a new battery.

15

BATTERY INSTALLATION

Advertising