Allied Air Enterprises A80UH2V - Manual (Page 30)

506471-01 Page 30 of 41 Issue 1034
START-UP
Lighting Instructions
For Your Safety, Read Before Operating
These furnaces are equipped with an ignition device which
automatically lights the burners. Do not try to light the
burners by hand.
Before operating, smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What to do if you smell gas:
• Do not try to light any appliances.
• Extinguish any open flame.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
Do not use this furnace if any part has been under water.
Immediately call a qualified service technician to inspect the
furnace and to replace any part of the control system and
gas control which has been under water.
IMPORTANT: Refer to the Lighting Instruction label on
the furnace for instructions on operating the specific
controls used on your unit.
1. Set the room thermostat to lowest setting.
2. Remove burner access door.
3. Move the gas control knob to the “ON” position. Use
only your hand to turn the gas control knob. Never use
tools. If the knob will not turn by hand, don’t try to repair
it; call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
4. Replace the burner access door.
5. Turn on the electrical power to the furnace.
6. Set room thermostat to a point above room temperature
to light the burners. After the burners have ignited, set
room thermostat to desired temperature.
To Shut Down Furnace:
1. Set the room thermostat to the lowest setting.
2. Turn off all electric power to the furnace.
3. Remove burner access door.
4. Shut off gas by moving gas control knob to “OFF” position.
5. Replace the burner access door.
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal
injury, or loss of life.
WARNING
Be sure the manual gas control has been in the “OFF”
position for at least 5 minutes before starting the unit.
Do not attempt to manually light the burners.
CAUTION
To Start Furnace:
Should overheating occur or the gas supply fail to shut
off, shut off the manual gas valve to the appliance
before shutting off the electrical supply.
WARNING