Avalon Stoves Indoor Fireplace - Manual (Page 36)

3 6
Safety Label
Travis Industries 4 0 5 0 5 2 5 1 0 0 - 0 1 1 4 4
Minimum Clearance to Combustible Materials
(Measured from insert top)
Adjacent Sidewall A 8.75 in
Mantel B 11.5 in
Top Facing C 6.25 in
Side Facing D 7 in
WARNING - DO NOT REMOVE OR COVER THIS LABEL
Listed Pelletized Solid Fuel Burning Appliance
For use in masonry or factory built (ZC) fireplaces.
Model: Astoria Bay PI (Avanti PI) Electrical Rating: 115 V., 60 Hz.,
Report No.: 028-S-51-2 Start 3 Amps,
Tested to: ASTM E1509-95 Run 1.5 Amps
Maximum Input Rating: 5.5 lbs (2.50 kg)/hr
This pellet appliance has been tested and listed for use in manufactured homes
in accordance with Oregon Administrative Rules 814-23-900 through 814-23-909.
Install and use only in accordance with the installation and operating
instructions. Contact local building or fire officials about restrictions and
installation inspection in your area. Do not remove bricks or mortar from
masonry fireplace or alter factory built fireplace.
Combustible floor beyond hearth extension must be protected by a non-combustible material, extending 6 in/150 mm (E) to the front and 6 in/150 mm (F) to the sides of door
opening. Do Not Connect This Unit to a Chimney Flue Serving Another Appliance. Components Required for Masonry Fireplace and Factory Built Fireplace Installation: Listed
4 in diameter flue liner.
For use with 1/4 in/6 mm to 5/16 in/7 mm diameter pelletized wood fuels that comply with premium grade standards set by Association of Pellet Fuel Industries. Replace glass
only with 5 mm ceramic glass available from your dealer.
DANGER: Risk of electric shock. Disconnect power before servicing unit. Do not route power cord beneath heater. The space beneath the heater must not be obstructed. Do
not obstruct combustion air openings. Operate only with viewing door closed and with ashbox and ashpan in place. Keep all furnishings well away from heater. Do Not Overfire
– If Heater or Chimney Connector Glows, You Are Overfiring. Inspect And Clean Chimney Frequently – Under Certain Conditions of Use, Creosote Buildup May Occur Rapidly.
HOT WHILE IN OPERATION. DO NOT TOUCH. KEEP CHILDREN, CAUTION
CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN
BURNS. SEE THE NAMEPLATE AND INSTRUCTIONS. OPERATE THIS UNIT ONLY WITH THE
FUEL HOPPER LID CLOSED. FAILURE TO DO SO MAY RESULT IN EMISSION OF PRODUCTS
OF COMBUSTION FROM THE HOPPER UNDER CERTAIN CONDITIONS. MAINTAIN HOPPER
SEAL IN GOOD CONDITION. DO NOT OVERFILL HOPPER.
Serial No.
2003
2004
2005
2006
Jan.
Feb.
Mar.
Apr.
May
Jun.
Jul.
Aug.
Sep.
Oct.
Nov.
Dec.
DATE OF MANUFACTURE
Travis Industries, Inc.
10850 117th Pl. NE
Kirkland, WA 98033
INSERT CLEARANCE DIAGRAM
MANTEL
F
ACIA
OR TRIM
SIDEW
ALL
B
A
F
E
C
D
HEARTH EXTENSION
Pellet
Insert
0468 (IGN)