Asus P7F-M User Manual
Page 122
5-28
Chapter 5: RAID configuration
2.
Enter a name for the recovery set and press <Enter>.
3.
When the
RAID Level item is selected, press the up/down arrow key to select
Recovery, and then press <Enter>.
4.
When the
Disks item is selected, press <Enter> to select the hard disk drives
you want to include in the recovery set. The
SELECT DISKS screen appears.
5.
Use the up/down arrow key to select a drive, press <TAB> to select a Master
disk, and then press <SPACE> to select a Recovery disk. A small triangle
marks the selected drive. Press <Enter> after completing your selection.
6.
When the
Sync item is selected, use the up/down arrow key to select a sync
option that you want and press <Enter>.
7.
When the
Create Volume item is selected, press <Enter>. The following
warning message appears.
[ SELECT DISKS ]
Port Drive Model Serial # Size Status
0 ST3160812AS 9LS0HJA4 149.0GB Non-RAID Disk
1 ST3160812AS 9LS0F4HL 149.0GB Non-RAID Disk
2 ST3160812AS 3LS0JYL8 149.0GB Non-RAID Disk
3 ST3160812AS 9LS0BJ5H 149.0GB Non-RAID Disk
Select 1 Master and 1 Recovery disk to create volume.
[↑↓]-Prev/Next [TAB]-(M)aster [SPACE]-(R)ecovery [ENTER]-Done
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
8.
Press <Y> to create the recovery set and return to the main menu, or <N> to
go back to the
CREATE VOLUME menu.
If a recovery set is created, you cannot add more RAID sets even when you
have more non-RAID disks installed in your system.