Ambient Devices WS-0100 - Manual (Page 2)

Version 1.0 ©Copyright 2010, Ambient LLC. All Rights Reserved. Page 2
1. Introduction
Thank you for your purchase of the Ambient Weather WS-0100 Advanced Weather Station with time,
indoor temperature and outdoor temperature and outdoor humidity. The following user guide provides
step by step instructions for installation, operation and troubleshooting. To download the latest manual
and additional troubleshooting tips, please visit:
http://ambientweather.wikispaces.com/ws0100
2. Getting Started
The WS-0100 weather station consists of a display console (receiver), and a thermo-hygrometer
(remote transmitter).
2.1 Parts List
QTY Item
1 Display Console
Frame Dimensions (LxWxH): 4.5 x 2.5 x 1.0 in
LCD Dimensions (LxW): 2.25 x 1.75”
1 Thermo-hygrometer transmitter (WH-2) with mounting bracket
Dimensions (LxWxH): 3.5” x 2.5” x 0.9”
2.2 Recommend Tools

Philips screwdriver (precision)

Drill for mounting bracket
2.3 Thermo-Hygrometer Sensor Set Up
Note: To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Remove the battery door on the back of the sensor with a Philips screwdriver (there is only one screw,
at the bottom of the unit). Insert two AAA batteries as shown in Figure 1 (we recommend lithium
batteries for cold weather climates, but alkaline batteries are sufficient for most climates).
Replace the battery door and set screw. Note that the temperature and humidity will be displayed on
the LCD display. Looking at the back of the unit from left to right, the polarity is (-) (+) for the top
battery and (+) (-) for the bottom battery.