Accessories, Liability disclaimer – Ambient Devices WS-0100 User Manual
Page 7
Version 1.0
©Copyright 2010, Ambient LLC. All Rights Reserved.
Page 7
Problem
Solution
Move the remote sensor to a higher location. Move the
remote sensor to a closer location.
Radio Frequency (RF) Sensors cannot transmit through
metal barriers (example, aluminum siding) or multiple,
thick walls.
Temperature sensor reads too high in the
day time.
Make sure the thermo-hygrometer is mounted in a
shaded area on the north facing wall. Consider the
following radiation shield if this is not possible:
Indoor and Outdoor Temperature do not
agree
Allow up to 30 minutes for the sensors to stabilize due to
signal filtering. The indoor and outdoor temperature
sensors should agree within 4 °F (the sensor accuracy is
± 2 °F)
Multi-channel Humidity do not agree
Allow up to 30 minutes for the sensors to stabilize due to
signal filtering. The multi-channel sensors should agree
within 10% (the sensor accuracy is ± 5%)
Humidity is reading 20% at low humidity
or 95% at high humidity
The humidity sensor is out of range (20 to 95%)
Display console contrast is weak
Replace console batteries with a fresh set of batteries.
8. Accessories
The following software and hardware accessories are available for this weather station at
.
Accessory
Image
Description
AA lithium batteries for cold weather
climates.
Solar Radiation Shield improves temperature
accuracy for hot weather climates. Remove
the rain guard and install over
thermo-hygrometer.
The WS-0100 supports up to three remote
channels (one is included).
9. Liability Disclaimer
Please help in the preservation of the environment and return used batteries to an authorized depot.
The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in