Ambient Devices WS-0100 - Manual (Page 4)

Version 1.0 ©Copyright 2010, Ambient LLC. All Rights Reserved. Page 4
Use 3 screws to affix the mounting bracket to the wall. Connect the remote sensor to the wall
bracket with a precision screwdriver.
Figure 3
4. Console Operation
Note: After 30 seconds of inactivity, the display will automatically revert to the normal display
mode (automatic time out).
4.1 Set Time and Units
Note: In 12 hour mode (USA), the temperature will display °F. In 24 hour mode, the temperature
will display °C.
Note: The SET and MIN/MAX functions use the same button and are used interchangeably. The
RESET and CH/+ functions use the same button and are used interchangeably.
Press the SET key for two seconds, and 12H will flash. Press the CH/+ key to switch between the 24
hour (24H) and 12 hour (12H) time display mode. Press the SET key to confirm 12/24 hour format
selection.
The hour will begin flashing. Press the CH/+ key to advance the hour. Note that the PM icon will be
displayed for afternoon hours. Press and hold the CH/+ key to advance rapidly. Press the SET key
to confirm the hour selection.
The minute will begin flashing. Press the CH/+ key to advance the minute. Press and hold the CH/+
key to advance rapidly. Press the SET key to confirm the hour selection.
4.2 Min/Max Mode
While in Normal Mode, press the MIN/MAX key to enter the minimum mode, and the MIN icon and
minimum records will be displayed at the bottom of the display. Press and hold the RESET key for
two seconds to reset the minimum values to the current values.
Press the MIN/MAX key to enter the maximum mode, and the MAX icon and maximum records will
be displayed. Press and hold the RESET key for two seconds or more to reset the maximum values to
the current values.
Press MIN/MAX key again to return the Normal Mode.