ARCHOS TV Plus 500973 - Manual (Page 74)

MANUAL V1.0
TV+
TROUBLESHOOTING > P. 74
TROUBLESHOOTING
RESTARTING / RESETTING YOUR ARCHOS
In the event that your ARCHOS freezes or does not respond anymore, disconnect
VJGRQYGTCFCRVGTYCKVHQTUGEQPFUCPFTGEQPPGEVKV9JGPVJGTGF.'&KPFK-
cator stops blinking, press the Power button on the supplied remote control to
turn on your device.
ONLY use the Reset button, on the back of the device, if you need to relaunch
the Installation Wizard. When you press this button, the ARCHOS will restart and
COGUUCIGYKNNRQRWRVQEQPÒTOVJGTGNCWPEJQHVJGYK\CTF+H[QWFQPQVTG-
URQPFYKVJKPUGEQPFUVJGYK\CTFYKNNDGCWVQOCVKECNN[TGNCWPEJGF5GG  The
Installation Wizard .
ATTENTION: if you use the reset button and relaunch the wizard, no data will
be erased but your TV connection settings will be lost, and you will have to set
them up again through the wizard.
SYSTEM RECOVERY
If your ARCHOS does not respond correctly, or does not show certain songs or
videos that you have copied to it, try using the “
Repair and Formatting Tools
”
(see: System Settings ).
If using the “
Repair and Formatting Tools
” does not solve your problem, you can
try a system recovery. It allows you to repair the hard drive, format it, etc.
4GUVCTV[QWTFGXKEG
FKUEQPPGEVVJGRQYGTCFCRVGTYCKVHQTUGEQPFUTGEQP-
nect it).
The red indicator starts blinking, and after a few seconds, it will start blinking
faster. While the red indicator is blinking faster, press the
TV
button on the re-
mote control to access the Recovery mode.
If the image does not appear, press the TV button and wait for a few seconds.
Repeat this operation until you can see the recovery screen (white back-
ground).
While you are in recovery mode, use the navigation buttons of the remote control to
move from one option to another and press OK to validate.
•
•
•
•

2.