Aiwa XR-EM20 - Manual (Page 10)

10
En
RADIO OPERATIONS
Manual tuning
1 Press TUNER/AUX/BAND (TUNER/BAND on the
remote control) repeatedly to select a band.
2 Press f or g repeatedly to tune in a station.
"TUNE" is displayed when a station is tuned in.
"1" is displayed for FM stereo reception.
To search for a station automatically (Auto search)
Hold down f or g.
The unit searches for a station and stops at reception.
To stop the search manually, press f or g.
•Auto search may not stop at stations with weak signals.
Preset tuning
Preset up to 32 of your favourite stations and tune them in
directly.
Presetting stations
1 Tune in the desired station.
2 Press SET on the remote control to store the
station.
The preset number, beginning from "1" flashes on the
display.
3 Repeat steps 1 and 2 to preset other stations.
The next station will not be stored if a total of 32 preset
stations have already been stored. ("FULL" is displayed.)
•If power is interrupted for more than approximately 12 hours,
all settings stored in memory after purchase need to be reset.
Tuning in preset stations
1 Select the band.
2 Press PRESET + ,- on the remote control
repeatedly.
With each press, the station with the succeeding or
preceding preset number is tuned in.
You can tune in the desired preset station directly by
pressing the numbered buttons on the remote control.
- To select preset number 11, press +10 and 1.
- To select preset number 15, press +10 and 5.
To clear a preset station
1 Tune in the station by preset tuning.
2 Press s, then press SET on the remote control within 6
seconds.
Preset station numbers in the band which are higher than
the cleared number decrease by one.
s
f , g
TUNER/
AUX/BAND
SET
TUNER MODE
0–10, +10
PRESET + , -
TUNER/BAND
POWER
f , g
SHIFT