LG LAB540W - Manual (Page 59)

5 Troubleshooting
Troubleshooting 59
Trouble
shoo
ting
5
Troubleshooting
General
Symptom Cause & Solution
The Power does not turned on. y Plug the power cord into the wall outlet securely.
The unit does not start
playback. y Insert a playable disc. (Check the disc type, color system, and regional
code.)
y Insert the disc with the playback side down.
y Clean the disc.
y Cancel the Rating function or change the rating level.
The connected USB storage
device is not recognized. y Try using different USB cable, some USB cables may not support
enough current for normal USB operation.
y If you use an USB extension cable or USB HUB, the USB devices may
not be recognized.
y An USB device which requires additional program installation when
you have connected it to a computer is not supported.
y This unit supports only USB Flash Drive and USB External HDD with
FAT32 or NTFS format.
The angle cannot be changed. y Multi-angles are not recorded on the DVD Video being played.
Cannot play video, photo or
audio files. y The files are not recorded in a format that the unit can play.
y The unit does not support the codec of the video file.
The remote control does not
work properly. y The remote control is not pointed at the remote sensor of the unit.
y The remote control is too far from the unit.
y There is an obstacle in the path of the remote control and the unit.
y The batteries in the remote control are exhausted.
The unit is plugged in, but the
power will not turn on or off. You can reset the unit as follows.
y Unplug the power cord, wait at least five seconds, and then plug it in
again.
The unit is not operating
normally.