Agilent Technologies J3972A - Manual (Page 24)

Introduction
Installation and Configuration Overview
4
Installation and Configuration Overview
To quickly install and configure your probe, it is important for you to understand
the available configuration and installation options. Configuration consists of
setting the probe parameters (IP address, for example). Installation consists of
physically installing the probe and connecting it to the network.
You will reference different chapters of this Installation/User’s Guide depending
on which of the following installation and configuration options you select:
z “Local Terminal Configuration and Installation” below
z “Installation and Bootp Server Configuration” below
Local Terminal Configuration and Installation
This method of installation and configuration requires that you configure the
probe first and then install the probe. These procedures are detailed in Chapter 2
“Local Terminal Configuration” and Chapter 3 “Installation”.
Installation and Bootp Server Configuration
This method of installation and configuration requires that you install the probe
first and then configure the probe. These procedures are detailed in Chapter 3
“Installation” and Chapter 4 “Bootp Server Configuration”.