Agilent Technologies J3972A - Manual (Page 36)

Local Terminal Configuration
16
Local Terminal Configuration
This chapter describes how to use a local terminal to configure your Agilent
J3919A or J3972A OC-3 ATMProbe so that it can communicate over a network.
If you plan to use the Bootp server method of configuration, skip to “OC-3 ATM
Interface Configuration” on page 33 and then continue with Chapter 3
“Installation”.
The following sections are covered in this chapter:
z “Probe Configuration Using a Local Terminal” on page 17
z “Using a Local Terminal” on page 19